Investigation of sintering mechanism for novel composite structural thermal barrier coating

Authors：Yang, Ting; Wang, Weize^*; Huang, Jibo; Liu, Yangguang; Li, Kaibin; Yang, Zining; Wang, Yihao; Yuan, Baohan; Zhang, Chengcheng

Source：Journal of the American Ceramic Society, 2023, 106(9): 5541-5558.

DOI：10.1111/jace.19164

• electron backscatter diffraction
• sintering mechanism
• structure design
• thermal barrier coating

A micro-agglomerated particle embedded-thermal barrier coating (TBC) structure was prepared by an improved plasma spray process to withstand the sintering-induced degradation of TBCs during service. In this study, the sintering resistance and thermophysical and mechanical properties of conventional and novel-structured TBCs were systematically characterized. The results suggested that the thermal conductivity and sintering shrinkage of the novel-structured TBCs were approximately 30% lower than those of conventional air plasma spraying TBCs. The elastic modulus of the novel-structured coating is only 32% of that of the conventional structure after thermal exposure at 1300 degrees C for 100 h. The distinct structure of the coating is the main factor that influences its performance. The relationship between the structural evolution and residual strain of the coating was analyzed using electron backscatter diffraction and transmission electron microscopy. Significant differences were observed in the sintering behavior of the dense matrix and embedded particle regions in the coating. Some columnar grains near the intersplat pores in the dense matrix have similar lattice orientations, and they tend to connect and consequently heal the intersplat pores. The large pores between the agglomerated particles and non-oriented submicron-sized grains that constitute these particles are responsible for the sintering resistance of the coating.

• Institution
  华东理工大学