摘要
A low-alloyed Mg-1.2Zn-0.1Ca (wt%) alloy was extruded at different temperatures (150 degrees C, 200 degrees C, 250 degrees C, 300 degrees C), and the effect of extrusion temperature on the microstructure and tensile properties was investigated systematically. While the as-cast alloy presented many cracks on the surface when extruded at 150 degrees C, it demonstrated good extrudability at temperatures above 200 degrees C. With increasing extrusion temperature from 200 to 300 degrees C, the average dynamic recrystallization (DRX) grain size increased from similar to 2.6 to similar to 6.4 mu m, and <10-10> texture gradually transformed to <11-21> rare-earth texture component. Solute segregation was observed along grain boundaries and dislocations. The sample extruded at 200 degrees C exhibited a superior combination of both strength and ductility, with a yield strength of 179 MPa, an ultimate tensile strength of 228 MPa and an elongation of 35%. The improved tensile properties were mainly attributed to the fine grain size together with a high density of dislocations. The basal slip Schmid factor increased with increasing extrusion temperature due to the attainment of full DRX microstructure and the presence of non-basal texture component, which resulted in a lower yield strength at higher extrusion temperatures. The findings pave the way for the development of low-cost and low-alloyed high-performance magnesium alloys via the strategy of tailoring extrusion temperatures.
学科与关键词
- Achieving superior mechanical properties in a low-alloyed magnesium alloy via low-temperature extrusionWang, H.; Zhang, D. T.*; Qiu, C.; Zhang, W. W.; Chen, D. L.*Materials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing , 2022, 851: 143611.被引 17
- Enhanced Strength-Ductility Synergy in Mg-0.5 wt%Ce Alloy by hot ExtrusionYu, Hui; Liu, Yu; Liu, Ya; Wang, Dongliang; Xu, Yuling; Jiang, Binan; Cheng, Weili; Huang, Lixin; Tang, Weineng; Yu, Wei*Metals and Materials International, 2023, 29(7): 2109-2116.被引 3
- Achieving superior strength-ductility synergy in a heterostructured magnesium alloy via low-temperature extrusion and low-temperature annealingWang, H.; Zhang, D. T.*; Qiu, C.; Zhang, W. W.; Chen, D. L.*JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY, 2023, 163: 32-44.被引 3
