摘要
Ultrafine-grained (UFG) Ti-6Al-4V alloy with average grain sizes of 305, 430, and 669 nm was fabricated by high-energy ball-milling and spark plasma sintering. The mechanical behaviors of consolidated titanium alloy with different grain sizes were studied under uniaxial compression at the quasi-static strain rate of 1 x 10(-3) s(-1) and high strain rates ranging from 0.5 x 10(3) to 2.9 x 10(3) s(-1). Shear bands can be observed in specimens tested under quasi-static and dynamic condition. It is discovered that when the grain size decreases, the flow stress increases and shear band instability takes place at lower strains. The flow stresses of UFG titanium alloy with different grain sizes demonstrate similar dependence on the strain rate when the strain rate ranges from 1 x 10(-3) to 0.5 x 10(3) s(-1). However, the strain rate sensitivity m dramatically increases at higher strain rates and is reduced with the decrease of grain size. It is considered that the propensity for adiabatic shear banding chi(ASB) during dynamic compression is increased with the reduction of grain size because of the improved yield strength as well as the diminished strain rate sensitivity.
学科与关键词
- Effect of Grain Size on the Shear Banding Behavior of Ti-6Al-4V Alloy Under Quasi-Static CompressionLong, Yan*; Peng, Liang; Zhang, Weihua; Peng, Haiyan; Zhang, Jinfu; Huang, XiaolongMetallurgical and Materials Transactions A: Physical Metallurgy and Materials Science , 2020, 51(5): 2064-2071.被引 5
- Shear Localization and its Related Microstructure Mechanism in a Fine-Grain-Sized Near-Beta Ti AlloyWang Bingfeng*; Sun Jieying; Hahn Eric Nicholas; Wang XiaoyanJournal of Materials Engineering and Performance, 2015, 24(1): 477-483.
- Microstructure evolution and shear band formation in an ultrafine-grained Ti-6Al-4V alloy during cold compressionLong, Yan*; Liao, Kebo; Huang, XiaolongMaterials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing , 2022, 856: 144026.被引 5
