ScholarMate
English简体中文繁體中文
客服热线:400-1616-289
登录注册
期刊论文

Excellent cryogenic mechanical properties of a novel medium-entropy alloy via vanadium-doping and hetero-grain/precipitation engineering

Peng, Hanlin*; Hu, Ling; Li, Likun; Wang, Haiyan; Zhang, Yupeng; Huang, Siming; Li, Liejun; Baker, Ian
Materials Characterization2024-1DOI: 10.1016/j.matchar.2023.113600
4阅读
引用收藏
分享

摘要

A novel vanadium-doped f.c.c. medium-entropy alloy (MEA) Ni42.4Co24.3Cr24.3Al3Ti3V3 was designed to achieve excellent cryogenic mechanical properties. The vanadium was added in order to increase the temperature dependent friction stress, and aging of the MEA, which had been given a homogenization anneal at 1150 degrees C followed by cold-rolling to 80% reduction, at 700-900 degrees C was used both to produce partial recrystallization and precipitate L12 nanoparticles. Aging produced a heterogeneous microstructure composed of fine, soft recrystallized grains surrounded by harder, relatively-large non-recrystallized grains, containing L12-precipitates. Increasing the aging temperature from 700 degrees C to 900 degrees C promoted V partitioning into the f.c.c. matrix with the partitioning coefficient increasing from 0.8 to 1.9; the grain size increasing from 2.3 mu m to 4.6 mu m; an increase in the precipitate size from 10.5 nm to 80.0 nm; a reduction in the residual geometrically-necessary dislocation (GND) density from 9.0 x 1014 m(2) to 2.8 x 1014 m(-2); and a decrease in the volume fraction of precipitates fraction from 28% to 14%. All three aged MEAs showed extraordinary cryogenic mechanical properties with an increase in the aging temperature resulting in an increase in strength but a decrease in ductility, viz, a yield strength (YS) of 1929 MPa, an ultimate tensile strength (UTS) of 2147 MPa, and an elongation to failure (epsilon) of 6.6% at 700 degrees C, YS 1735 MPa, UTS 1976 MPa, epsilon 9.0% at 800 degrees C, and YS 1274 MPa, UTS 1694 MPa, epsilon 24.8% at 900 degrees C. The dislocation back stress rose progressively with increasing strain and was invariably higher than the effective stress, accounting for 51-59% of the flow stress i.e. the back stress played a dominant role in the ultrahigh flow stress. Increasing the aging temperature also produced a greater abundance of nano scale deformation twins, stacking faults, and dislocation networks, which are responsible for excellent strain hardening capacity and greater ductility. After deformation, the density of low-angle grain boundaries increased by 3-6 times to 0.6-1.3 mu m/mu m(2), and the GND density increased by 4-6 times to 1.2-2.0 x 10(15) -2.

学科与关键词

关键词
Medium-entropy alloysHeterogeneous grainsCryogenic mechanical propertiesBack stressDeformation mechanismsStrengthening mechanisms
相关
加载中…
  • An investigation on microstructure and mechanical properties of strong yet ductile nanoparticle-strengthened, partially recrystallized, medium-entropy alloy
    Peng, Hanlin*; Huang, Siming; Hu, Ling; Baker, IanIntermetallics, 2024, 166: 108182.
  • Thermal stability of microstructure and their influences on mechanical properties of precipitation-hardened medium-entropy alloy Ni43.4Co25.3Cr25.3Al3Ti 3
    Peng, Hanlin*; Hu, Ling; Huang, Siming; Zhang, Yupeng; Yi, Yaoyong; Li, Liejun; Baker, IanMaterials Characterization, 2023, 203: 113156.被引 3
  • Microstructures and deformation mechanisms of the medium-entropy alloy (NiCoCr)76(Ni6AlTi)3
    Peng, Hanlin*; Hu, Ling*; Chen, Junfu; Huang, Siming; Li, Liejun; Yi, Yaoyong; Zhou, Feng; Fang, Weiping; Baker, IanMaterials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing , 2022, 849: 143449.被引 6
查看全部 →

发表信息

论文状态
公开发表
期刊
Materials Characterization
发表日期
2024-01
卷期
第 207 卷
页码
113600
DOI
10.1016/j.matchar.2023.113600
语言
ENGLISH
成果收录
SCIE
资助标注
Guangdong Basic and Applied Basic Research Foundation [2022A1515110390]; Guangzhou Basic and Applied Basic Research Foundation [2023A04J0994]; Science and Technology Planning Project of Guangdong Province [2022GDASZH-2022010107]; Ministry of Science and Technology of the People's Republic of China [2020GDASYL-20200301001]; GDAS' Project of Science and Technology Development; [2022B1212050001]; [2020YFE0205300]

作者

  • P

    Peng, Hanlin (通讯) (第一作者)

  • H

    Hu, Ling

查看全部 8 位作者收起作者
  • L

    Li, Likun

  • W

    Wang, Haiyan

  • Z

    Zhang, Yupeng

  • H

    Huang, Siming

  • L

    Li, Liejun

  • B

    Baker, Ian

登录解锁更多功能

  • 收藏这篇,随时在“我的 · 收藏”找回
  • 认领你的成果,生成推广素材
  • 关注作者获取最新成果
  • 加入项目组、协同写作
注册 / 登录

产品服务

  • 科研之友
  • 创新城
  • 科创云

服务支持

  • 帮助中心
  • 隐私政策
  • 服务条款

联系方式

在线客服:【】
客服热线:400-1616-289
电子邮箱:support@scholarmate.com

关注或下载科研之友

微信二维码
微信公众号
客户端下载二维码
下载客户端
科研成果科研人员科研机构科研动态爱瑞思软件

©2026 深圳市科研之友网络服务有限公司

公安备案图标粤公网安备 44030502000213
粤ICP备 16046710 号粤B2-20110417